Look up how to clean vinyl flooring and the same two products keep coming up: soft soap, also known as green soap, and vinegar. They are exactly the two that don't belong on vinyl. Soft soap leaves a greasy film that is holding on to dust again by tomorrow. Vinegar is acidic and eats into your protective layer. The list of what you can use is shorter than you think, and that's good news.
Why vinyl is a special case
You're not cleaning the vinyl, you're cleaning the layer on top of it.
A vinyl floor (PVC, often sold as LVT) is built up in layers. At the bottom is the backing, above that the printed layer that mimics wood or tile, and on top of it all a clear wear layer. That wear layer does all the work: it takes the scratches, it keeps moisture out, and it decides how your floor looks. Damage it and there's no repairing it, because the colour sits underneath.
That's the whole story of cleaning vinyl. Whatever you do has to leave that one layer alone. Getting the dirt off is easy, because vinyl isn't porous and lets almost nothing soak in. The damage nearly always comes from the cleaner, not from the dirt.
Is the cleaner pH-neutral? Acidic and strongly alkaline products both eat into the wear layer.
Does it leave anything behind? A film that stays on the floor holds on to dust and turns dull.
What should never go on vinyl
This is the list floor fitters agree on, and most of the classic home remedies are on it.
| Product | Suitable | What it does |
|---|---|---|
| Soft soap | No | Too alkaline, leaves a greasy film that attracts dirt |
| Vinegar and cleaning vinegar | No | Acidic, eats into the wear layer over time |
| Bleach and chlorine cleaners | No | Attacks the material and discolours it |
| Abrasive cleaners and scourers | No | Scratches the wear layer, and that layer doesn't grow back |
| Multi-purpose cleaner with lemon | No | Citric acid, the same problem as vinegar |
| Floor oil and wax polish | No | Won't bond to vinyl, turns sticky and traps dust |
| Mild multi-purpose cleaner, diluted | Yes | No lemon, no vinegar, well diluted |
| pH-neutral vinyl floor cleaner | Yes | Does the job, but you'll rarely need it |
| Just water | Yes | Enough on most days |
Soft soap is the most common mistake. It sounds gentle and natural, and on untreated wood it really is the right product. On vinyl it does the opposite of what you want: it leaves a thin greasy layer, dust sticks to it, and your floor gets dirty faster than before. If you mop with soft soap every week and can't work out why the floor keeps getting duller, the cause is sitting in your bucket.
What to clean vinyl flooring with instead
Nine times out of ten, all you need is water.
Vacuum or sweep first. It's not the boring step you get to skip, it's the step that decides whether the rest works: mop over loose grit and you drag that grit across your wear layer, making exactly the scratches you wanted to avoid.
Then use a damp mop, not a wet one. Vinyl copes with water, but the joints and the edges along the skirting boards don't always, and with self-adhesive planks moisture creeps under the glue. Damp means you wring the mop out until nothing more comes out, and the floor behind you is dry before you reach the other side.
-
+
Nothing is also an option. Whatever you don't put on the floor, you never have to get off it again.
-
+
Work in strips and switch to a clean mop head as soon as it turns grey, otherwise you're just moving the dirt around.
-
+
No need to dry afterwards if you mop damp. If you do have to dry the floor, your mop was too wet.
If there is grease, in the kitchen for example, add a splash of mild multi-purpose cleaner to a bucket of water. Keep it well diluted, then go over the floor once more with clean water so nothing is left behind. Most people skip that last step, and it's exactly the one that decides whether your floor shines or turns dull.
Streaks, dull patches and stains
Streaks almost never come from your floor and almost always come from your bucket. Too much cleaner, or too little clean rinse water. The fix isn't a different product but less product: mop the floor once with nothing but clean water and the streaks are gone.
A dull floor is usually build-up. Layer upon layer of cleaner that has been left behind, often soft soap or a cleaner that promises shine. You get it off with warm water and a damp mop, two or three times, with fresh water each time. You don't need polish for this; polish is just one more layer.
Stains are best tackled as soon as you can, because vinyl isn't porous but the edges of a dried-on stain do cling. Warm water and a cloth do most of the work. If something is still there, put a tiny amount of mild multi-purpose cleaner on the cloth, not on the floor, then rinse with clean water.
What you don't do is scrub with anything abrasive. A scourer takes off the stain and the shine along with it, and you only see the difference when the light hits the floor at an angle.
What about a steam cleaner?
Whether you can also use steam depends on your floor. Check with the manufacturer or supplier of your floor.
The full story, covering every type of floor, is in which floors a steam cleaner can handle.
Frequently asked questions
What can you use to clean vinyl flooring?
Water, and if there's grease, a splash of mild multi-purpose cleaner, well diluted. Beyond that, a pH-neutral vinyl floor cleaner if you already have one in the house. You don't need anything more, and anything extra you use has to come off again later.
What shouldn't you use on vinyl flooring?
Soft soap, vinegar and cleaning vinegar, bleach and chlorine cleaners, abrasive cleaners and scourers, multi-purpose cleaners with lemon, and floor oil or wax polish. The first two are on that list even though they're the ones recommended most often.
What can't a vinyl floor handle?
Acid, strong alkalis and abrasion. It isn't the vinyl itself that suffers but the clear wear layer on top, and that can't be repaired because the colour sits underneath. It also doesn't like standing water in the joints or heat on an adhesive layer.
How do I get my vinyl floor looking good again?
Usually by doing less, not more. A dull vinyl floor is almost always build-up of cleaner that has been left behind. Go over it two or three times with warm water and a damp mop, using fresh water each time, and the shine comes back. If the wear layer itself is scratched, cleaning won't help any more.
Can you clean vinyl flooring with vinegar?
Better not. Vinegar is acidic and eats into the wear layer over time, even if you see nothing the first few times. On tiles vinegar is fine, as there's no delicate layer on top. On vinyl, use water, or mild multi-purpose cleaner if water isn't enough.
Why do I get streaks on my vinyl floor?
Almost always from too much cleaner or too little clean water. Mop the floor once with nothing but clean water and a well wrung-out mop, and they're gone. Buying a different product won't solve it, because the problem is that there's already too much on the floor.
How often should you clean vinyl flooring?
Vacuum or sweep as often as needed, because loose grit is what scratches. Mopping is needed far less often than people think, because vinyl doesn't absorb anything. Once a week with water is enough for most households.
Can you use a floor scrubber on vinyl flooring?
With a soft pad, yes; with an abrasive pad, no. The same rule applies as by hand: the wear layer decides how your floor looks, and an aggressive pad will strip it off in a few goes.
Around the house
Thinking of steam cleaning yourself? Our IXYLUX Omni 10 works with water only and has a low and a high setting.